XBMC the Thecus N3200 NAS and NFS

After getting OpenELEC installed on an SD card and running on my Raspberry Pi, the next step was to get XBMC serving up all the media that is stored on our Thecus N3200 NAS.

It looked like it should be pretty straight forward, as I already have various NFS mounts setup on the NAS for access via my Kubuntu laptop. However, I just couldn’t get XBMC to browse into any of the mounted folders; it could see them, just not access them.

There isn’t much information out there about my NAS, mainly as it was superseded pretty quickly by the N3200PRO. Which meant that there wasn’t much information with which to try and diagnose the issue. After a bit of googling, I did manage to track down a post that implied that my NFS mounts would need to invoke insecure mode, which was backed up by the XBMC wiki. Shame the N3200 doesn’t expose any real NFS settings, so you can’t configure the mounts from the frontend; at least not with the last official firmware.

I did look at adding the insecure flag the NFS mounts directly, via the /etc/exports file; shame that you can’t SSH into the NAS by default though. After a bit more trawling, I found a couple of modules that would allow me to reset the root password and run a SSH demon. With the modules loaded, I SSH’d into the NAS and added the insecure flag to each of the NFS mounts; shame the changes were lost when I rebooted. I eventually gave up trying and asked for help on the Thecus forums, I haven’t had a reply yet.

While I wait on a reply, I just added the various mounts to XBMC via SMB. It’s not my first choice, but it appears to work fine, at least there were no obvious streaming issues while I watched Ratatouille last night…

One thought on “XBMC the Thecus N3200 NAS and NFS”

Leave a Reply